|
Perform all types of work involved with the installation, rearrangement, maintenance, operation, removal and inspection of electrical transmission and distribution facilities., The following list sets forth the principal duties required for the job. All items apply to overhead and underground, as applicable. This list is not intended to limit assignment of work or the degree of supervision under all operating conditions. Employee may perform miscellaneous, related, and incidental work in addition to that specifically outlined below.
Perform duties in accordance with the Company's safety rules, regulations and practices and report unsafe conditions and practices.
Install and maintain transmission and distribution facilities and all types of line equipment on the most congested types of construction, energized or de-energized.
Assemble, install, maintain, remove and inspect conductors, fixtures and other associated equipment on overhead and underground facilities.
Operate cutouts, line switches, reclosers and other sectionalizing devices; re-fuse line and transformer devices; change line and transformer taps; phase out and/or parallel circuits.
Work with live line equipment on energized circuits for emergency repairs or routine modifications of facilities.
Make energized cut overs from old poles and equipment to new or temporary installations.
Select proper standard drawings and interpret specifications and proceed with all new construction work and live line work without supervision.
Direct crew when assigned and exercise leadership and good judgment when in charge.
Locate and clear away dangerous conditions and repair facilities to restore and maintain service. Place danger signs and/or flares, flag traffic, and place barriers as required to protect the public.
Operate mechanized equipment required to install, remove or maintain overhead and underground transmission and distribution facilities.
Obtain, issue, accept and release transmission and distribution clearances or permits in accordance with established switching and tagging procedures.
Know and follow proper procedures for performing switching on all types of transmission and distribution lines and stations.
Install, maintain and switch underground residential distribution and commercial facilities. Locate and correct trouble using cable locating and fault finding tools and equipment.
Connect, phase out, parallel and adjust voltage on single and three-phase transformer installations.
Use test equipment such as voltmeters, ammeters, maxi-meters, recording meters, phase rotation tester and other electrical test equipment associated with line work, at all voltages, including investigation of customer complaints.
Install three-phase regulator banks and energize or remove from service.
Install, maintain, operate and remove capacitor banks from service.
Patrol and inspect lines and stations as assigned.
Instruct customers regarding meter or service locations, and advise customers regarding service interruptions related to customers' electrical equipment.
Maintain tools, equipment and work area in a clean and orderly condition.
Maintain records and submit reports as required.
Assist employees of equal or higher classification.
Attend and participate in training as assigned and assist in the training of other employees.
Prepare, conduct and facilitate safety meetings.
Perform similar or less skilled work.
Report irregularities and abnormal conditions. Minimum Requirements 1. Minimum of two years satisfactory work experience as a Lineman B or the equivalent.
2. Shall have performed the duties of and have all the qualifications of Lineman B or the equivalent and shall qualify through demonstration, examination and/or performance appraisal as determined by the Company.
3. Must have a good working knowledge of Company safety rules and practices and be proficient in the application of resuscitation and first aid.
4. Must have a good working knowledge of various circuit connections, voltage identification of lines, phasing, transformer connections and switching devices. Must know the fundamentals of electricity and have the ability to interpret field prints and switching diagrams.
5. Must possess and maintain a valid state Class A Commercial Driver's License. Must meet all vehicle operation requirements as designated by federal and/or state law.
6. Must have a good working knowledge of the tools, materials and equipment used.
7. Must have a good working knowledge of the Company's transmission and distribution standards.
8. Must possess the ability to deal with employees, customers and the general public in a courteous and proper manner.
9. Must possess the ability to plan work and to properly instruct others.
10. Successful completion of the Construction and Skilled Trades (CAST) selection test is required for this position. A review of Employment Testing Information, Test-Taking Tips, and the CAST Practice Test may be helpful. A link to these materials may be found at AEP.com Careers by selecting Employment testing. A physical abilities assessment is also required for this position.
11. Must live within 30 minute distance under normal driving conditions to the Henderson Operations Center.
|
